Pontiac G8 Carbon Fiber Cowl Hood

Another long over due part for the G8 market!

There have been far too many hideous hood designs out there for the G8!  Some so hideous you wouldn't put it on your mother in-laws car and unfortunately there hasn't been much options for the forgotten G8.  Now there is!

This hood is designed like any other Maverick Man Carbon Fiber Product. The lines will match from every angle you look at it and it will utilize all of the factory mounting points!

• This hood weights in at 25 lbs and easy 19+ lbs off the front of your G8.

• Uses all OE mounting points for latch and hood struts. Holes must be drilled in areas if you wish mount your OE hood liner.

• 4 inch Cowl Rise with rear venting.

• Full 100% Carbon Fiber top with a full Fiber Glass Frame support.  THIS IS NOT A "LAYOVER" or a "SKIN" product. 

Please note that this hood is for OFF ROAD USE ONLY! It is mandatory that you use hood pins or another locking device for safety reasons!

$1299 plus shipping +CA Tax   (Hood must be shipped by truck line). 

The Hood must be shipped by truck line. Shipping has increases dramatically since the price of fuel and supply chain issues. Shipping can now range from starting at the high $200 to mid $300s depending where you are in the US. If you have questions about our lead time please email us first at maverickman@maverickmancarbon.com.

If the hood is out of stock and have questions about how to get one please refer to this link here.

As stated it is Mandatory that you use some sort of hood latching system on this hood. We offer a few alternatives.

We recommend using Mirror Glaze Synthetic Sealant 2.0 by MEGUIAR'S to keep your hood looking great!

TERMS AND CONDITIONS for Purchase of Carbon Fiber Hood from Maverick Man Inc.

All orders placed with Maverick Man, Inc. (phone, fax, mail, verbal, or
e-mail), directly or in any other way constitute the acknowledgment and
acceptance of all of the conditions listed below:

 
Warranty & Disclaimer

Products sold by Maverick Man, Inc. may not be street legal in all states. It is solely the buyer's responsibility to ensure compliance with local, state, and federal regulations.

Due to stringent U.S. safety and crash standards, Maverick Man, Inc. assumes no liability for any injuries or damages resulting from accidents caused by driver error, improper installation, poor judgment, or natural events—including acts of God, nature, or any higher power the buyer recognizes.

All products are designed exclusively for off-highway use and must be used for their intended purposes only. Maverick Man, Inc. is not responsible for damage resulting from buyer installation, modification, or excessive stress placed on the products.

The buyer is responsible for determining product suitability and is expected to take full precautions during installation. Maverick Man, Inc. shall not be held liable for any direct or indirect damage to vehicles, drivers, passengers, or property.

🛠️ Limited Warranty: Maverick Man Carbon offers a limited 6-month warranty from the date of purchase on all hoods.

Important Installation & Warranty Guidelines

All products require professional installation.

Some items may need minor modifications or adjustments as part of the normal fitting process.

Hood pins are mandatory for all hoods to ensure safety.

Carbon fiber components are not designed to withstand heavy force or weight and may crack if subjected to pressure.

Maverick Man, Inc. strives to design aftermarket products that closely match OEM fitment. However, additional preparation or adjustments (like fenders, hood latch and hood hinges) may be necessary to achieve optimal results. It is the buyer’s responsibility to ensure proper fitment before installation.

🎨 Painting Notice: If you plan to paint the product, you must pre-fit all parts to the vehicle prior to painting. Once painted, returns are not accepted under any circumstances.

🔥 Engine Bay Insulation Required: For vehicles equipped with a supercharger or turbocharger, hood insulation is mandatory. Even for naturally aspirated vehicles, insulation is required to maintain warranty coverage.

Recommended options include:

Termo Shield

Dynamat

Or our specially matched liner: Black Under Hood Thermal Acoustic Liner HERE: https://tinyurl.com/484xz5ht

🚫 Do Not Use Clear Bra Films Applying a clear bra or similar film to carbon fiber surfaces prevents heat from escaping, leading to moisture buildup and potential damage. This will void your warranty.

 
Carbon Fiber Hood Care Instructions

To preserve the appearance and durability of your new carbon fiber hood, proper care is essential. Carbon fiber is highly sensitive to UV exposure, and neglect can result in damage that voids your warranty.

☀️ UV Protection is a Must

Always apply a high-quality UV protectant.

We recommend using ceramic coatings or detailers formulated with strong UV-blocking properties.

Standard wax is not sufficient—do not rely on it alone.

Adding a clear coat layer can help, as these hoods feature a gel coat, not a factory clear coat.

🚫 Avoid Prolonged Sun Exposure Treat carbon fiber like your skin—extended exposure to direct sunlight over consecutive days can lead to “sunburn”–like damage. Protect it accordingly.

🧴 Recommended Products

Meguiar's Mirror Glaze Synthetic Sealant 2: https://amzn.to/35vRDU3

💧 Moisture Management Avoid leaving your hood outdoors in cold climates, especially if your vehicle sits. Moisture buildup under the engine bay, combined with daytime heat, can evaporate through the carbon and leave fogging or hard water-like spots under the gel coat that damage your hood and void your warranty.

🚫 Do Not Use Clear Bra Films Never apply clear bra or similar films to carbon sections. These trap heat and moisture under the surface, resulting in damage and warranty voidance.

 
Shipping Damage Policy

Maverick Man, Inc. takes great care when packing products to minimize the risk of damage during transit. However, shipping damage may still occur occasionally, and it is crucial that the buyer follows the proper inspection and documentation process upon delivery.

📝 Upon Receipt:

Inspect both the packaging and product thoroughly in the driver’s presence.

If there are any signs of damage, such as crushed, torn, punctured boxes or broken, crushed and over all damaged to the part, note these issues directly on the freight bill or delivery receipt.

🚫 DO NOT allow the driver to document damage for you. You must personally write in the notations. 

💻 Electronic Signatures:

If using an electronic system with no comment field, type “DAMAGED” in the signature box.

If no field is available at all, clearly write “DAMAGED” on any accompanying paperwork.

If someone else is signing on your behalf, make sure they are fully aware of these procedures.

📦 Retain All Packaging: Keep the original boxes, packing materials, and damaged items intact for inspection by the carrier’s damage assessor.

🚫 Do Not Refuse Delivery:

Do not refuse or return the shipment without prior written approval from Maverick Man, Inc.

Refusing delivery or failing to follow the documentation process may result in loss of claim rights.

✅ Reminder: A signed receipt without any damage notation releases both the carrier and Maverick Man, Inc. from future responsibility. Any damage discovered after a clear delivery becomes the customer's responsibility.

 
 
Damage Reporting Instructions – Time Sensitive

To initiate a damage claim, the following steps must be completed within 24 hours of delivery:

📸 Photographic Documentation

Take clear photos of any damage to the product.

Include shots of all packaging, even if it appears undamaged.

🚫 Important: Do NOT send photos via email. Claims submitted this way will be delayed and considered non-compliant with stated terms.

☁️ Upload & Submit

Upload all images to a public link via Google Drive, Dropbox, or WeTransfer.

Then, send an email to Maverick Man Carbon Inc. that includes:

Your order number

The public image link Once received, we will begin processing your claim.

⏳ Failure to follow these steps within 24 hours may result in denial of the claim.

 
Carrier Claim & Replacement Process

If damage is properly notated on the delivery receipt at the time of delivery, the carrier will assess the situation and determine whether to cover repair costs or issue a replacement value reimbursement. The replacement value is defined as the amount paid to the distributor by the buyer and is non-negotiable.

📌 Important Notes:

Any disputes regarding the settlement amount must be resolved directly with the carrier.

Maverick Man, Inc. bears no responsibility for the damaged product or any claim settlements resulting from carrier inspection.

In some cases, the initial damaged product may need to be destroyed (ie: Cut into four pieces) by the receiver, at their own expense.

Proof of destruction will be required before a replacement product can be issued.

Each damage case will be evaluated individually.

🚫 Do Not File a Claim Yourself To avoid confusion and delays, do not file a claim with the shipper directly. Maverick Man, Inc. will initiate and manage the damage claim process on your behalf.

 
Defective Product Policy

All products must be professionally installed. Minor modifications or adjustments (to fenders, hood latch and hood hinges) may be required and are considered part of the normal installation process and not signs of defect.

Please note:

Most carbon fiber components are hand-crafted, meaning that no two items will be exactly identical.

Subtle imperfections such as wavy weaves, visible lines in the fiber pattern, small bubbles, excess adhesive, or gel coat blemishes—are normal characteristics of the material and manufacturing process.

📸 Return Criteria To qualify a product as truly defective and eligible for return, clear photos must be provided showing issues that exceed the accepted norms above.

Return Packaging Policy – Preserve All Materials

🚫 Do not discard any packaging materials until you're certain the product will not require return. This includes both sides of the shipping box, the interior wood supports, and all styrofoam inserts.

📦 All returns must be shipped using the original packaging the product was delivered in. Failure to retain and reuse the full original packing may result in denial of return authorization or damage during transit.

By replying to this email, you confirm that you have read, comply and understood all Terms and Conditions.

Thank You

Maverick Man Inc.